elguapo wrote:If you are using slydways field texture and it warps then don't use that field texture. Use an original madden field texture and no warping will appear.
insert the attachment into the endzone2 spot, it should eliminate the warping issue.
No, all along I've been using the default Madden turf field that has red & blue lines on the 50 yd line (stadata file #29). Anyway, I just tested again with your file #10 to be certain, and the result is the same. (For what it's worth, the warping at the goal-line is hard to spot when using Madden's default fields as reference since the lines are so blurry, but it's most noticeable along the 50. Much easier to spot at the goal-line when using TrueTurf and TexMod though.)
Interesting though, 'cos I just came back to this thread to find out more about the ST35 field you mentioned earlier!
When I looked it up, I found I had forgotten that it refers to the NFL shield on the 25yd lines. I actually asked about the possibility of using that
HERE almost 8 months ago, but had dismissed it myself (incorrectly of course!).
My very first encounter with any sort of ghost lines was trying to remove one unsuccessfully from the Panthers logo on their 25yd line. But I've only just realized that that logo was NOT in the ST35 field of course, but actually part of the field texture itself! My bad!!
I'm very grateful you looked into it properly elguapo, and have come up with an even better solution!
I'm desperate to try this out now and I promise you now have my full attention!
I've just found your much earlier post
HERE that lists the relevant file numbers, so I'll check this out tomorrow as soon as I get a moment.
For what it's worth, I recently did one final test with endzone2 which was the final nail in the coffin for me, which you can read about
HERE.
Much obliged for your continual insights elguapo!